Now it's also NuRAD firmware! Set define for compile option NURAD in hardware.h to switch. Added a new little thing for NuEVI too: releasing the rollers leaves octave in current one instead of going to bottom octave unless coming down from first roller. This is helpful against bass hum from filter leak when setting the EVI aside, using pitch CV from NuEVI and synth with no VCA in use or gate open (drone mode).

NuEVI/hardware.h

@@ -2,6 +2,81 @@
 #define __HARDWARE_H
 
 #define REVB
+//#define NURAD
+
+#if defined(NURAD) //NuRAD <<<<<<<<<<<<<<<<<<<<<<<
+
+// Pin definitions
+
+// Teensy pins
+
+//Capacitive sensor pins (on-board teensy)
+#define bitePin 17
+#define extraPin 16
+#define pbUpPin 1
+#define pbDnPin 0
+#define vibratoPin 15
+
+//Analog pressure sensors. Breath and optional bite
+#define breathSensorPin A0
+#define bitePressurePin A7
+
+//Digital pins for menu buttons
+#define dPin 3
+#define ePin 4
+#define uPin 5
+#define mPin 6
+
+//Output pins for LEDs (breath, power, status)
+#define bLedPin 10
+#define pLedPin 9
+#define eLedPin 22
+#define sLedPin 23
+#define statusLedPin 13
+
+//Analog input for measuring voltage
+#define vMeterPin A11
+
+//DAC outputs for analog and pwm
+#define dacPin A14
+#define pwmDacPin A6
+
+//Which serial port to use for MIDI
+#define MIDI_SERIAL Serial3
+
+// MPR121 Rollers 0x5D
+
+#define rPin1 0
+#define rPin2 1
+#define rPin3 2
+#define rPin4 3
+#define rPin5 4
+#define rPin6 5
+
+// MPR121 RH 0x5C
+
+#define RHsPin 3
+#define RH1Pin 4
+#define RH2Pin 2
+#define RH3Pin 1
+#define RHp1Pin 0
+#define RHp2Pin 8
+#define RHp3Pin 7
+#define spec1Pin 10
+#define spec2Pin 9
+
+// MPR121 LH 0x5B
+
+#define LHsPin 8
+#define LH1Pin 7
+#define LHbPin 1
+#define LH2Pin 9
+#define LH3Pin 10
+#define LHp1Pin 11
+#define LHp2Pin 3
+#define LHp3Pin 4
+
+#else //NuEVI <<<<<<<<<<<<<<<<<<<<<<<
 
 // Pin definitions
 
@@ -102,6 +177,7 @@
  */
 
 #endif //REVB
+#endif //NURAD
 
 
 #endif